CAME zl92 - Function Configuration - Part 8

F
i
F34
0 I
i
2
ENTER
> >
ENTER
>
>
>...>
F
i
F44
0 I
i
2
ENTER
> >
ENTER
>
>
>...>
F
i
0 I
I I
ENTER
> >
ENTER
>
>
>...>
I00
F54
F
i
0
F64
i
ENTER > > ENTER
>...>
F
i
0
F05
i
ENTER > > ENTER
>...>
F
i
0
F i5
i
ENTER > > ENTER
>...>
P. 20 - Manual code: 319V21EN Vers. 3 04/2017 © CAME cancelli automatici S.p.A. - The data and information in this manual are subject to change at any time without prior notice required by Came Cancelli Automatici S.p.A.
ENGLISH
F 43 (Point when M2 motor draws fully open) : adjusts the point at which the M2 motor begins drawing to the fully-open posi-
tion.
This point is calculated as a percentage of the full gate run (see paragraph illustrating the slow-down areas and points at which
gate draws fully open or closed)
1 = 1% of the gate run; .................. 5 = 5% of the gate run (default setting); .................. 10 = 10% of the gate run.
F 44 (Point when M2 motor draws fully closed) : adjusts the point at which the M2 motor begins drawing to the fully-closed
position.
This point is calculated as a percentage of the full gate run (see paragraph illustrating the slow-down areas and points)
1 = 1% of the gate run; .................. 5 = 5% of the gate run (default setting); .................. 10 = 10% of the gate run.
F45 (Additional closing slow-down point) : adjusts the point at which there is an additional slow-down when closing, calculated
as a percentage of the slow-down.
Note: this function is visible only for the straight-arm Myto and Stylo gearmotors.
10 = 10% of the slow-down run; ............ 50 = 50% of the slow-down run (default setting); ............ 100 = 100% of the slow-
down run.
F 46 (Number of Motors) : sets the number of motors connected to the control panel.
0 = Engages both the M1 and M2 motors (default setting); 1 = Engages only one, the M2 motor.
F 50 (Save data) : saves all users and settings in the memory roll.
Note: this function appears only if the memory roll is inserted into the mother board.
0 = Deactivated; 1 = Activated
F 51 (Data Read out) : loads the data from the memory roll into the mother board.
Note: this function appears only if the memory roll is inserted into the mother board.
0 = Deactivated; 1 = Activated.