CAME ZLB24SA - RIO Safety Devices; Rio Ed T1; Rio Ed T2; Rio Ph T1

Page 37 - Manual FA01894-EN - 09/2022 - © CAME S.p.A. - The contents of this manual may be changed at any time and without notice. - Translation of the original instructions
RIO ED T1 and RIO ED T2
Associate one of the available functions with a wireless safety device.
The function only appears if the RIO CONN interface board is present.
Confi guration>
RIO safety devices
RIO ED T1
RIO ED T2
Deactivated (Default)
P0 = It stops the gate and excludes automatic closing. Use
a control device to resume movement.
P7 = Reopen while closing.
P8 = Reclose while opening.
RIO PH T1 and RIO PH T2
Associate one of the available functions with a wireless safety device.
The function only appears if the RIO CONN interface board is present.
Confi guration>
RIO safety devices
RIO PH T1
RIO PH T2
Deactivated (Default)
P1 = Reopen while closing.
P2 = Reclose while opening.
P3 = Partial stop. Only with [Automatic close] activated.
P4 = Obstacle standby.
P13 = Reopening during closure with immediate stop once
the obstacle has been removed, even with the gate not in
motion.
Photocell BUS <n>
Associate a function with the photocell BUS <n> input.
<n> is between 1 and 8 and corresponds to the address set on the photocell dip-switch
The function only appears if there is a BUS photocell connected.
Confi guration>
BUS Devices
BUS Photocell 1
Photocell BUS 2
Photocell BUS 3
Photocell BUS 4
Photocell BUS 5
Photocell BUS 6
Photocell BUS 7
Photocell BUS 8
Deactivated (Default)
C1 = Reopen while closing (photocells)
C2 = Reclose while opening (photocells)
C3 = Partial stop Only with [Automatic close] activated.
C4 = Obstacle standby (photocells)
C13 = Reopen while closing, with immediate closure once
the obstruction has been removed, even if the gate is not
in motion
Open
Close