CAME ZLB24SA - I;O Module 1; BUS Fl Ashing Beacon

Page 39 - Manual FA01894-EN - 09/2022 - © CAME S.p.A. - The contents of this manual may be changed at any time and without notice. - Translation of the original instructions
I/O module <n> - Light output
Associate a function to the I/O module <n> input 1.
<n> is between 1 and 2 and corresponds to the address set on the module dip switch.
The function only appears if there is a BUS I/O module connected.
Confi guration>
BUS Devices>
I/O module 1
I/O module 2
Light output Passage-open warning light - It notifi es the user of the
operator status.
See function [Passage-open warning light].
Cycle lamp - The lamp stays on during the manoeuvre.
Courtesy light - The light switches on when a manoeuvre
starts and remains on once the manoeuvre has fi nished,
for the time set under the [Courtesy time] function.
I/O module <n> - Relay output
Associate a function to the I/O module <n> input 2.
<n> is between 1 and 2 and corresponds to the address set on the module dip switch.
The function only appears if there is a BUS I/O module connected.
Confi guration>
BUS Devices>
I/O module 1
I/O module 2
Relay output Bistable
Monostable - on from 1 to 180 seconds (Default 1)
<Opening colour> BUS fl ashing beacon
Set the BUS fl ashing beacon colour during operator opening.
The function only appears if there is a BUS fl ashing beacon connected.
Confi guration>
BUS Devices>
BUS fl ashing beacon
Opening colour Red (Default)
Purple
Blue
Light blue
Green
White
Yellow
Orange
<Closing colour> BUS fl ashing beacon
Set the BUS fl ashing beacon colour during operator closing.
The function only appears if there is a BUS fl ashing beacon connected.
Confi guration>
BUS Devices>
BUS fl ashing beacon
Closing colour White
Yellow
Orange
Red (Default)
Purple
Blue
Light blue
Green