2 06/2013 © CAME cancelli automatici s.p.a. -
The data and information reported in this installation manual are susceptible to change at any time and without obligation on CAME cancelli automatici s.p.a. to notify users.
ENGLISH
<
-oooooooooooo+
>
< Disabled >
< C1 >
< C4 >
< C2 >
< C3 >
< Turn on >
<Disabled>
< CX+CZ >
<CX+CY+CZ>
< CX+CY >
< CY+CZ >
<Maintained Act>
<Obstacle Det.>
<Safety d.Test>
< Preflashing >
< Total Stop >
< CX Input >
<CZ Input>
<Lock>
< Config. >
<Ram hit funct.>
< end stop >
< cmd 2-7 >
<dmd 2-3P>
<output B1-B2>
< C7 >
< C8 >
< Slow run >
<Fcap-RallCh> < Limit switch>
< Time of Run >< encoder >
<Cl. Thrust.>
<No.Motors>
<Motor type>
<High speed%>
<low Down Spd>
<Slow Star>
<Sens.Amperom>
<run Amperom.>
<Slow down time>
<M1+M2>
< M2 >
Frog
FROG-J
< 50 >
< 100 >
< 10 >
< 50 >
< Turn on >
<Disabled>
< Turn on >
<Disabled>
< 0s. >
< 30s. >
< Turn on >
<Disabled>
<Autoclose>
AMICO
AXO
FERNI
FAST
<
-oooooooooooo+
>
< Turn on >
<Disabled>
< Turn on >
<Disabled>
<Disabled>
< Turn on >
<Disabled>
< Turn on >
<Disabled>
<Open-Close>
<Op.-Stop-Cl.>
<Pedestrian>
< Parzial >
< Bistable >
<Monostable>
< N.C. >
< N.O. >
< Disabled >
< C1 >
< C4 >
< C2 >
< C3 >
< C7 >
< C8 >
< Disabled >
< C1 >
< C4 >
< C2 >
< C3 >
< C7 >
< C8 >
< Disabled >
< CX >
< CY >
< CZ >
<CY Input>
<when close >
<Disabled>
Close >
< Open >
< Open-Close >
< lamp E >
lamp E
<Courtesy>
lamp E
<Cycle>
lamp E
Flashing light
•
•
Appear on the menu, only if any excluded <Encoder> configuration is
enabled.
Appear only if the <Decelaration> or <fcap-Rall CH> configurations are
enabled.
< Lock >
Close >
< Open >
< Open-Close >
To Next Page
Loading...
