CAME ZLJ24 - Encoder Acceleration Points and Calibration; M1 and M2 Opening Acceleration Points; Gate Run Calibration Procedure

X10
X 2
X 8
X 2
X 8
X 2
Pag.
22
22 - Manual code:
319U98EN
319U98EN ver.
2
2 06/2013 © CAME cancelli automatici s.p.a. - The data and information reported in this installation manual are susceptible to change at any time and without obligation on CAME cancelli automatici s.p.a. to notify users.
ENGLISH
FUNCTION
S
TIMING ADJ
.
US
ER
S
I
NF
O
ENCODER
I
mp.
R
u
n
< Set Encoder >
Set Encoder
<confirm?(no)>
Set Encoder
<confirm?(yes)>
See detailed
description on
page 31
Gate run calibration: calibrates the gate’s opening and closing runs and decelerations.
< M2 Appr.AP % >
5
M2 Appr.AP %
< 5 >
M2 Appr.AP %
< 6 >
<
LAN
G
UA
G
E
>
E
ng
li
s
h
F
UN
C
TI
O
N
S
TIMING ADJ.
.
US
ER
S
I
NF
O
ENCODER
TEST MOT.
TEST MOT.
< M1 Appr.AP % >
5
M1 Appr. AP %
< 5 >
M1 Appr.AP %
< 6 >
< LAN
GU
A
G
E
>
E
n
gli
s
h
F
U
N
C
TI
O
N
S
TIMIN
G
AD
J.
USER
S
INF
O
ENCODER
M2 Acc. Opening &: sets the point at which the gate begins adjusting deceleration before making contact with the opening endpoint of
the second motor (M2).
The beginning point of adjustment is calculated as a percentage ( between 1% and 15%) of the total gate run time.
See illustration on page 32.
M1 Acc. Opening %: sets the point at which the gate begins adjusting deceleration before making contact with the opening endpoint of
the fi rst motor (M1).
The beginning point of adjustment is calculated as a percentage ( between 1% and 15%) of the total gate run time.
See illustration on page 32.