page 6
The pump sometimes gets a rock
or piece of trash stuck in it and needs
to be cleaned. The procedure is
simple.
The first thing to do is to remove the
stocking from the pump to gain ac-
cess to it.
Follow the instructions on the en-
closed pump warranty.
Special Note:
The fuse is your only protection
against burn out ! ALWAYS check
the pump for debris In any event that
the pump does not pump water when
it is turned on. Never substitute a
fuse bigger than 6 amperes rating.
Never operate pump dry or if it is
clogged and not pumping water.
Pump Details
Place stocking over pump
LIFT AND HOLD LEVER
TURN TOP OF PUMP AND LIFT
TO OPEN PUMP.
REMOVE MOTOR
CARTRIDGE TO
CLEAN IMPELLER
PUMP IMPELLER
To Previous Page
Loading...