26
CHECKING AND MAINTENANCE
%HIRUH DQG DIWHU HDFK XVH FKHFN WKH FRUUHFW RSHUDWLRQ RI DOO PRYLQJ SDUWV LQFOXGLQJ WKH IXQFWLRQ RI WKH
spring action of the movable cam [6] and the actuating lever [4], and the correct operation of the anti-panic
GHYLFH &KHFN IRU WKH SUHVHQFH RI GLUW RU IRUHLJQ REMHFWV WKDW FDQ DƪHFW RU SUHYHQW RSHUDWLRQ HJ JUHDVH
grit, sand, pebbles, etc.). Cleanliness: use a damp cloth (fresh water) and clean all the visible parts, then dry. Do not
use solvents. Do not submerge the product in water. After cleaning, lubricate the visible pins of the moving parts
with a silicone-based lubricant spray. Note: cleaning and lubrication are recommended after each use in a marine
environment.
REVISION
7KH VDIHW\ RI XVHUV GHSHQGV XSRQ WKH FRQWLQXHG HƯFLHQF\ DQG GXUDELOLW\ RI WKH HTXLSPHQW ,Q DGGLWLRQ WR WKH
normal inspection required before, during and after each use, this product must be inspected by a skilled person
HYHU\ PRQWKV VWDUWLQJ IURP GDWH WKH SURGXFW LV ƬUVW XVHG WKLV GDWH DQG WKH VXEVHTXHQW FKHFNV PXVW EH
recorded on the product’s life sheet: keep this literature for inspection and reference for the life of the device.
Check the legibility of the product’s markings. In case of one of the following defects are present, the product
should be withdrawn from service immediately:
• Presence of cracks on any component,
• Presence of permanent deformations on any component,
• 8QDXWKRULVHG PRGLƬFDWLRQ WR WKH SURGXFW ZHOGLQJ GULOOLQJ HWF
• &RUURVLRQ WKDW VHYHUHO\ DƪHFWV WKH VXUIDFH VWDWH RI WKH PHWDO ZKLFK GRHV QRW GLVDSSHDU DIWHU VOLJKW UXEELQJ ZLWK
emery paper,
• Malfunction of the mechanisms of the actuating lever [4], the connecting lever [7], the movable cam [6],
• %XUUV DQGRU VKDUS HGJHV RQ DQ\ VXUIDFHV WKDW FRXOG FRPH LQ FRQWDFW ZLWK WKH URSH HVSHFLDOO\ RQ WKH PRYDEOH FDP
[6] WKH Ƭ[HG FDP [5], the front plate [2], and the rear plate [1],
• VLJQLƬFDQW ZHDU RQ DQ\ SDUW RI WKH GHYLFH !PP
• breakage or loss of the mechanism cover [8].
Any product or component showing any defect or wear, or if in doubt, should be withdrawn from service
immediately. Each product in the safety system can be damaged during a fall and must be always inspected before
use it again. Do not continue to use a product after a major fall because a damage may have occurred, even no
external signs are visible.
LIFETIME
The lifetime of the product is unlimited, unless any defect appears and provided that periodic inspections are made
DW OHDVW RQFH HYHU\ PRQWKV IURP WKH GDWH WKH SURGXFW LV ƬUVW XVHG DQG WKH UHVXOWV DUH UHFRUGHG LQ WKH OLIH VKHHW
of the product. The following factors can reduce the lifetime of the product: intense use, damage to components of
the product, contact with chemical substances, high temperatures, tears and abrasions, violent impacts, failure to
PDLQWDLQ DV UHFRPPHQGHG :KHQ VXVSHFW WKDW WKH SURGXFW LV QR PRUH VDIHW\ DQG UHOLDEOH SOHDVH FRQWDFW &$03
SpA or the distributor.
TRANSPORTATION
Protect the product from risks such as those detailed above.
To Next Page
Loading...
