FT-244 Cirrus
Garden Terrace Fountain
Assembly Instructions
Fountain Information:
• This fountain holds approximately 1 gallon of water.
• A fountain cover is not available for this fountain.
• No refill device or submersible lights are suggested for this fountain
Pump Information:
WP450LV - 120 GPH Low Voltage Pump
Tools Required:
Bubble Level
Screwdriver
Scissors
Pump Kit Parts List
Image Component Quantity
PK120-LV Pump with Transformer 1
#7 Stopper 1
2" length of PermaGum Putty 1
Approx. 6" length of 1/2" black
non-kink tubing
1
1" length of 5/8" clear vinyl tubing 1
1" length of 1/2" PVC pipe 1
Adhesive Dots 4
Hose Clamps 1
Fountain Components
Image Item Description
Component
Item #
Quantity
Cirrus Garden
Terrace
Fountain Water
Feature
FT-244A 1
Equinox Garden
Terrace
Fountain Basin
FT-243B 1
Proudly
MADE IN USA
Fountain Set-Up:
Assembly & Installation - A fountain can be dicult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help: Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation: Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem o, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop: To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet: Use only a GFCI outlet when running a fountain.
rev 02/22/2024
SHOP NOW
To Next Page
Need help?
General
