8. Select the Settings Editor tab then Cellular. The PPP Authentication Username and PPP
Authentication Password fields, must not be used. If these fields contain information, you
will need to have Campbell Scientific update your module firmware, see If you don't have
direct access to the data logger nor a copy of LoggerNet (p. 15).
9. Scroll to the Cell Diagnostic Info field.
The current version of the cellular module firmware is listed next to Brio Ver.
If it is greater than the version listed below, you do not need to update the module
firmware.
- CELL200: 1.1.11 or greater
- CELL205: 1.1.11 or greater
- CELL210: 2.00.101.06 or greater
Cellular Module Firmware Update 5
To Next Page
Loading...
