Campbell CR300 series - Page 9

Other messages may indicate that there was a problem.
A successful update of the -CELL210 should look like this:
CR300>CELL UPDATE
Are you sure? (YES/NO)
CR300>YES
Restarting cellular modem please wait . . .
Setting up modem for master reset.
Full modem reset successful.
Restarting modem in firmware update mode . . .
Waiting for modem initialization . . .
Cellular module version:2.00.101.02
Radio status:0,0
APN command sent . . .
APN Set. Waiting for modem registration . . .
Radio status:1,0
Connect status:2,3,88
Sending firmware update command . . .
Firmware update command sent . . .
Waiting for command reply . . .
Response received . . .
Firmware update started.
Please wait . . .
Firmware update command was successful.
Please wait . . .
Firmware update time : 00:30
Firmware update time : 01:00
Firmware update time : 01:30
Firmware update time : 02:00
Cellular module version:2.00.101.06
Firmware update successful.
Cellular update finished.
NOTE:
You must see Firmware update successful on the line before Cellular update finished.
Other messages may indicate that there was a problem.
15. Repeat steps 8 and 9 of this section to confirm the module firmware update was successful.
Once the cellular module update is complete, the module will come back online and the
CR3X0-CELL2XX will be ready for use. If the update was not successful, the data logger with
return a Firmware update failed. message in the terminal. Check to see if the data logger is
reporting that the module is back online by checking the State field under Deployment >
Cellular.
Cellular Module Firmware Update 7