This button allows to delay the start of the
programme from 30 minutes (1 hour on
some models) to 24 hours in 30 minutes
intervals (1 hour on some models).The
delay selected is shown on the display.
After pressing the START/PAUSE button
the time showed decrease minute after
minute.
It's possible transform a cycle from
automatic to programmed, up to 3
minutes after the start of the cycle.
The progressive pressure increases the
time in 10 minute intervals. After this
selection to reset the automatic drying
functioning is necessary to switch off the
dryer.
In case of incompatibility, all indicator
lights flash quickly for 3 times.
This button allows you to store the options
set on a cycle.
MEMORY:
select the programme and the desired
options, then press the button MEMO for 3
seconds (before starting the cycle). The
writing MEMO (all the digit on some
models) will blink for 2 seconds and the
options connected to the cycle selected will
be set.
RECALL:
after the selection of the cycle press the
button MEMO for recall the stored options
(not the cycle).
This button allows to set the desired
dryness level editable option up to 3
minutes after the starting of the cycle:
Ready to Iron: it leaves the garments
slightly wet to facilitate ironing.
Dry Hanger: to get garment ready to
be hang.
Dry wardrobe: for laundry that can be
directly stored.
Extra-dry: to get completely dry
garments, ideal for full load.
This appliances is equipped with Drying
Manager function. On automatic cycles,
each level of intermediate drying, prior to
the reaching the selected one, is indicated
by flashing the light indicator corresponding
to the degree of drying reached.
In case of incompatibility, all indicator
lights flash quickly for 3 times.
During the cycle the option sets alternate
movements of the drum to reduce the
folds and automatically sets the drying
level to "Ready to Iron". Moreover this
option activate an anti-creases movement
of the drum pre cycle in case of activation
of the delay and at the end of drying
cycle. It is activated every 10 minutes, up
to 6 hours after the end of the drying
cycle.
To stop the movements set the programme
selector to OFF. Useful when it's not
possible to remove immediately the laundry.
Pressing simultaneously the buttons "C"
and "F" for about 2 seconds, the
machine allows you to lock the keys. In
this way, you can avoid making accidental
or
unwanted changes if a button on the
display is pressed accidently during a
cycle.
The delay start function can't be
memorized.
TIME CYCLE SELECTION button
Opening of the porthole with delayed
start set, after re-
closing the porthole,
press start again to resume the counting.
To Next Page
Loading...
