Candy CBT6RGX - Installing Grease Mesh Filters; Carbon Filter Installation

10
Filters should be washed separately to crockery and kitchen utensils. It is advisable
not to use rinse aid.
INSTALLING GREASE MESH FILTERS
• To install filters for the following four steps:
- Angle the filter into the slots at the back of the hood.
- Push the button on the handle of the filter.
- Release the handle once the filter fits into a resting position.
- Repeat to install all filters.
CARBON FILTER
Activated carbon filter can be used to trap odors. Normally the activated carbon filter
should be changed every 3 to 6 months according to your cooking habits. The
installation procedure of activated carbon filter is as below:
 Put the pin of the carbon filter into the rectangular hole of the fan(as per the
arrow A shown below)
 Push the other side of the carbon filter toward the fan to make it flat(as per the
arrow B shown),and then press filter into fan.
 If you want to remove the filter, press fastener of filter and remove it by turning
anticlockwise.
NOTE:
• Before replacing light that the cooker hood can be isolated from the supply
mains by means of a plug or an all-pole switch.
• When activated carbon filter attached, the suction power will be lowered.