Candy CDIMN 4S613PS - Memo Function for Last Programme; Demo Mode Enabling;Disabling

!
EN
107
! Open the door.
! Turn on the dishwasher by holding the
"ON/OFF" button down for about 3 secs.
! Hold down the "Progr." and "ON/OFF"
buttons for about 5 secs.
! The message "SETTINGS" will appear
on the display and the indicator lights of
the "OPTIONS" and "TABS" buttons will
be on.
! Pressing the "Progr." button until the
"MEMO FUNCTION" parameter is
selected.
! Parameter adjustment is performed by
pressing the "OPTIONS" (-) and "TABS"
(+) buttons to change the value from
"MEMO MODE ON" to "MEMO MODE
OFF" and vice versa.
! Switch off the dishwasher by pressing the
"ON/OFF" button for 3 secs to confirm
the new setting.
To turn the alarm on again, follow the same
procedure.
Enabling
1. Open the door.
2. Turn on the appliance using the
ON/OFF button.
3. Press the Progr. and "START DELAY"
buttons together for 5 seconds.
4. "DEMO MODE ON" will appear on the
display.
5. If no button is pressed for 30 seconds,
the programme will start, simulating the
start of a wash programme.
Disabling "Demo mode"
1. Open the door.
2. Turn on the appliance using the On/Off
button.
3. Press the Progr. and "START DELAY"
buttons together for 5 seconds.
4. "DEMO MODE OFF" will appear on the
display.
5. Switch off the appliance.
MEMO FUNCTION (Memorising
the last programme used)
The dishwasher must ALWAYS be off
before you start this procedure.
Enabling or disabling DEMO MODE
(be used exclusively in stores)
The dishwasher must ALWAYS be off
before you start this procedure.
The Progr./Options/Start Delay options
are enabled, and by pressing these
buttons you can simulate the product's
functioning without starting a wash.
WARNING
Once installed, if the appliance works
correctly but the wash cycle does not
start upon pressing the Start button,
"Demo mode" may not have been
disabled.
The dishwasher must ALWAYS be off
before you start this procedure.