Candy CH64FC - Page 12

10 GB
Heater dsplay Fault Acton
F0
Fc
Ft
FE
Fb
FU / FJ
FA
FC / Fd
Fr
If error has occurred disconnected and connect again the cooktop to the power supply. If error persist,
call after-sales service. If error appears suddenly in a normal operation, call after-sales service.
Touch control softwareerror.
Wait until temperature goes down. Cook-top will automatically recovered when temperature
reaches a normalvalue.
Touch control zone is too hot
and has turned off all the
heaters.
Wait until temperature goes down. If message persist when temperature reaches an environment
value, call after-salesservice.
Touch control temperature
sensor can bedamaged.
Wait until temperature goes down. If message persist when temperature reaches an environment
value, call after-salesservice.
Touch control temperature
sensor can bedamaged.
See if cook-topis mounted correctly.Be sure that keys touch correctly the glass surface.
Excessive sensitivity
on any key.
This error is a keyboard auto-check. It disappears when autocheck return to secure value. If error
persist, call after-sale service.
Security keyboard error
This error is a software auto-check. It disappears when auto-check return to secure value. If error
persist, call after-sale service.
Security software error
This error is a software auto-check. It disappears when auto-check return to secure value. If error
persist, call after-sale service.
Security software error
Any relay driver can have any problemn. Remove cook-top from the power supply, wait a minute
and switch on again. If error persist, call after-sale service.
Relays security error
“Valºd only for Cyprus”
12 / 150