268
You can edit out the first and last scenes of a movie in 1-sec.
increments.
1
On the movie playback screen,
select [X].
X The movie editing panel will be
displayed at the bottom of the screen.
2
Specify the part to be edited out.
Select either [U] (Cut beginning) or
[V] (Cut end), then press <0>.
Tilt <9> to the left or right to see the
previous or next frames. Holding it
down will fast forward the frames.
Turn the <5> dial for frame-by-
frame playback.
After deciding which part to edit out,
press <0>. The portion highlighted
in blue on the top of the screen is
what will remain.
3
Check the edited movie.
Select [7] and press <0> to play
back the portion highlighted in blue.
To change the editing, go back to step
2.
To cancel the editing, select [2] and
press <0>.
X
Editing the Movie’s First and Last Scenes
To Next Page
Loading...
