Canon EOS-1D Mark II - Click White Balance Function

Editing Images
2-15
2
Displaying Thumbnail Images and Performing Basic Edits in the Main Window
You can automatically adjust the white balance simply by clicking a point in a neutral part of the
image.
1
Click the [Click] button.
 When you move the cursor over
the image, the cursor [ ] changes
to [ ].
2
Click a point in a neutral part of the image.
 If you click on another point over
the image, the white balance is
adjusted again.
 If you finish this operation, click
the [Click] button or right-click.
 The coordinates of the cursor position and the RGB values (8-bit conversion) of an
image are displayed in the lower-left of the main window (2-2).
 The image is adjusted based on the value of 1  1 pixels from the clicked point.
 You can also adjust the white balance by clicking an achromatic color (neutral gray) part
of the image.
Click White Balance Function