Shot Settings
W-78
You can select tone curves, specify the sharpness and contrast, and then register up to three
sets of these settings on the camera as processing parameters.
For more information on setting the processing parameters on the camera, refer to “Setting
the Processing Parameters” in the camera’s Instruction Manual.
1
Click the [Parameters] button (W-77).
The [Parameters settings] dialog
box appears.
2
Select the [Set 1], [Set 2], or [Set 3] tab.
3
Specify the tone curve, sharpness, and contrast.
Specifying the Parameters
[Standard]:
The standard tone curve is set.
[TCD 1] through [TCD 3]:
The tone curve that has been
selected in “Specifying the
Tone Curve” (W-80) is set.
Drag the slider left or right to specify the sharpness.
Higher values give higher levels of edge sharpening.
Drag the slider left or right to specify the contrast.
Higher values give higher levels of contrast.
To Next Page
Loading...
