3
Troubleshooting
Printing Does Not Start
Phenomenon
The Data Reception Lamp on the
Control Panel does not light up
The printer does not respond even
if print jobs are sent
1.
2.
1.
2.
Ink Filling.. is displayed
Make sure the power cord is securely plugged in, all
the way. Press the Power button to turn on the printer.
Set Pause Print to Off .
In Windows, select the printer by clicking Select
Printer or Printer in the printing dialog box and try
printing again.
In Windows, restart the print job as follows.
In Mac OS X, select the printer by clicking Printer
Setup Utility (or Print Center ) and try printing again.
Select the printer icon in the Printers and Faxes (or
Printers ) window.
Clear Pause Printing in the File menu to restart the
print job.
In Mac OS X, restart the print job as follows.
Click Print & Fax . (This is identified as Printer
Setup Utility in some versions of Mac OS X.)
Select the printer, and then Start Jobs in the
Printers menu to restart the print job.
Wait until the system has been filled with ink. This
process may take about 12 minutes.
The printer is not on.
In the Control Panel menu, Pause
Print is On .
The printer is not selected in the
printer driver. (The printer is in
Sleep mode.)
The print job is paused. (The
printer is in Sleep mode.)
The printer was forced off during
operation.
Cause Corrective Action
The display screen indicates
Agitating
The time for agitation varies depending on how long
the printer was off. (Between about 30 seconds and
two minutes.)
Ink agitation is in progress.
(→"Pausing Printing," User Manual)
You have selected Save in mail
box in Output Method on the
printer.
Print the job saved on the printer's hard disk.
Print jobs are pending. Manage the jobs on hold and print as needed.
(→"Printing Saved Jobs," User Manual)
(→"Managing Pending Jobs (Printing or Deleting Jobs
on Hold)," User Manual)
Please wait until ink agitation is finished.
To Next Page
Loading...
Need help?
General