11
Perform Print Head Adjustment and Select the Connection Method
When the screen for selecting the
connection method appears, select the
connection method to use.
Note
• If you are connecting the printer to the network using a xed IP
address, select Do not connect. Congure the settings from the touch
screen of the printer after the printer has nished charging the ink for
the rst time and adjusting the print head.
Wired LAN connection
This is the method for connecting the printer to the
network using a LAN cable.
1
Tap Wired LAN connection.
Check the message about the connection
method and tap Yes if there are no problems.
2
A message prompting you to connect the
LAN cable appears.
3
Use the LAN cable to connect the wired LAN
connector on the back of the printer to the
hub port.
4
Tap OK.
Wireless LAN connection
This is the method for connecting the printer to the
network without using a cable.
1
Tap Wireless LAN connection.
Check the message about the connection
method and tap Yes if there are no problems.
2
A message prompting you to set up the
wireless LAN appears.
3
If you are conguring from a computer
-> Tap Yes.
If you are conguring from the printer
-> Tap No.
USB connection
This is the method for connecting the
printer to a computer using a USB cable.
Only 1 printer can be connected.
Do not connect the USB cable yet.
1
Tap USB connection.
Check the message about the
connection method and tap Yes if
there are no problems.
USB connection
Congure the printer and computer
connection settings and install the software
while the ink is charging for the rst time
and the print head is adjusting.
Proceed to "Connect to the Printer" on p.12.
The paper starts feeding, and then the printer automatically starts charging the ink for the rst time and adjusting the print head.
Charging the ink for the rst time and adjusting the print head for the rst time takes about 35 minutes.
Important
• Do not open the covers of the printer or turn the power off while the ink is charging for the rst time and the print head adjustment is executing.
Note
• If you selected Do not connect, the connection settings and software installation will need to be performed separately.
Proceed to "Connect to the Printer" on p.12.
• Charging the system with ink lls the system from the ink tanks to the print head. In addition, cleaning is performed to keep the printer in optimal condition. This
may cause the remaining ink indicator and maintenance cartridge capacity indicator to drop some amount. The starter ink tank is for rst-time installation. It is
recommended that you purchase replacement ink tanks quickly.
Wired LAN connection
Congure the printer and computer connection
settings and install the software while the ink is
charging for the rst time and the print head is
adjusting.
Proceed to "Connect to the Printer" on p.12.
Wireless LAN connection
If you are conguring from a computer
-> Congure the printer and computer connection
settings and install the software while the ink is
charging for the rst time and the print head is
adjusting.
Proceed to "Connect to the Printer" on p.12.
If you are conguring from the printer
-> Congure the wireless LAN settings from the printer
after the printer has nished charging the ink for the
rst time and adjusting the print head.
Proceed to "Congure Wireless LAN Settings on the
Printer" on p.13.
To Next Page
Loading...
Need help?
General
