Projector Monitoring Software Starter Guide
Step 1: To nd the default IP address of the REALiS
projector, PRESS the Menu button.
Step 2: PRESS the right-arrow button and scroll
over to the Information tab. Here is where
you will nd the projector’s default IP address.
NOTE: In order to change the projector’s IP
address, your computer’s IP address
must be in the same network as the
projector.
Step 3: Open up Internet Explorer and TYPE in the
projector’s default IP Address.
Step 4: The REALiS web page will open up.
TYPE in the following:
User Name: root (all lower case)
Password: system (all lower case)
Step 5: CLICK on the OK button.
Step 3
Step 4
Step 2
Step 5
Only works with REALiS Series Mark II and Mark II D projectors and Canon LV-Series projectors with a network port.
1. This is a EXAMPLE of how to use the Canon’s Projector Monitoring Software.
2. You will need to change the projector’s IP address to match your network settings.
3. Please make sure your computer meets the following System Requirements.
OPERATING SYSTEM Microsoft Windows XP Professional SP2 or later /
Microsoft Windows Vista Ultimate
CPU Intel Pentium 4 2.4 GHz or better
MEMORY 1 GB or more
.NET FRAMEWORK Windows XP: .NET Framework 2.0 SP1 or more /
Windows Vista : .NET Framework 3.0 or more
SUPPORTED LANGUAGES: English and Japanese
ACROBAT READER 7.0 or higher
Category Essential Requirements
D
DISCLAIMER
I
CHANGING THE IP ADDRESS ON REALiS PROJECTORS
To Next Page
Need help?
General
