EasyManua.ls Logo

Canon MARK III EOS-1 DS - Replacing the Date;Time Battery; Remove the Battery

Canon MARK III EOS-1 DS
212 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
188
The date/time (back-up) battery maintains the camera’s date and time.
Its service life is about 5 years. If the date/time is reset when the battery
is replaced, replace the back-up battery with a new CR2025 lithium
battery as described below.
The date/time setting will also be reset, so be sure to set the
correct date/time.
1
Set the power switch to <2>
and remove the battery pack.
The back-up battery is on the ceiling
of the battery compartment.
2
Remove the back-up battery
cover.
Use a small screwdriver to loosen the
screw and remove the cover.
Be careful not to lose the cover and screw.
3
Remove the battery.
4
Install a new back-up battery.
The plus side of the battery must face
up.
5
Attach the cover.
Replacing the Date/Time Battery
(+)
For the date/time battery, be sure to use a CR2025 lithium battery.
COPY

Table of Contents

Related product manuals