O3
C
0
0
Reserve Copy
This feature allows you to reserve the next job while the machine is printing out a current job.
1
2
3
4
5
NOTE
Tile machine can store up to 10 copy jobs in memory.
Press [Stop/Reset] twice to return to the standby display while the machine Is printing out.
NOTE
It is necessary to return to the standby display in order to reserve tile next copy job.
Place the document you want to reserve on the platen glass or load It In the ADF.
For details on how to place or load documents, see "Setting Up Documents," on p. 3-2.
Use the numeric keys to enter the number of copies.
You can set up to g9 copies.
Adjust any necessary settings for your document.
• Press ]Image Qualityj to select the scanning resolution. (See "Adjusting the Image Quality (Resolution)," on p.
5-3.)
• Press ]Exposure] to select the scanning exposure. (See "Adjusting the Exposure (Density]," on p. 5-3.)
• Press [Enlarge/Reducej to select the copy ratio. (See "Setting Enlarging/Reducing," on p. 5-2.)
• Press [Coliate/2onl] to perform the collate copy or 2 on 1 copy function.(See "Special Features," on p. 5-4.]
Press [Start].
The machine begins scanning.
NOTE
• After pdnting of tile current copy job is complete, the next copy job begins.
• If the memory becomes full while scanning, <MEMORY FULL> appears in the LCD When the ADF is used for
scanning, the document being scanned stops in the ADH Press [OK] to make the docufr;ent come out
automaticall W If the document does riot come out, it may be jarr_led in the ADE Follow the procedure in
"Removing Jarr_led Paper from the ADE "on p. 9-6 to clear the paper jam in the ADE
All of the scanned docurr;ents will be erased if <MEMORY FULL> appears, so divide the document and copy each
part separatelj4 or select a lower itnage quality mode and make copies again.
5-8
To Next Page
Loading...
