or 7
This chapter explains how to check the status of the jobs stored in the machine, and to confirm or delete them as
needed.
Use [Status Monitor] to confirm or delete copy, fax*, print and report jobs stored in the machine.
When using [Status Monitor], the LCD displays the jobs in the following order in each mode.
In Copy mode, In Fax mode*,
- COPY STATUS - RX/TX STATUS
- RX/TX STATUS* - TX/RX LOG
- TX/RX LOG* - PRINT STATUS
- PRINT STATUS - REPORT STATUS
- REPORT STATUS - COPY STATUS
* Only for the MF5750/MF5770 models.
z_ NOTE
[Status Monitor] is disabled in the Scan mode.
Confirming and Deleting a Fax Job
Follow the procedure below to confirm the sending or receiving status.
1 Press [Status Monitor].
2 Press [4 [-)] or [_[+)] to select <RX/TX STATUS> _ press [OK].
NOTE
• If there is no job, <NO CURRENT RX/TX JOB> is displayed.
• If there is only one fax job, go to step 4.
• The transaction numberand <TX/RX> in the LCD mean the following.
- <0001> to <4999>: A sent document (TX)
- <5001> to <9999>: A received document (RX)
7-1
To Next Page
Loading...
