Cleaning the ADF Area
Black lines may appear in copies when the ADF is used to feed documents.
This is caused by paste, ink, correction fluid, or other foreign matters in the read area of the platen
glass (shaded area). Use a clean soft cloth to wipe the read area clean. Take particular care to clean at
the locations where the black lines are appearing on copies.
If you have trouble getting the glass clean, wipe with a cloth moistened with water or a mild neutral
detergent, and then wipe the glass dry with another cloth.
Paste, ink,
correction fluid,
etc,
Black lines
o
Copy
c
White roller
IMPORTANT
• Paste, ink, correction fluid, and other foreign matter can soil the platen glass when you send a docurrlent #}rough
the ADF whfle the paste, ink, or correction fluid on the c2)cument is still wet. This is what causes black llrles on
copies. Whenever you load a document in the ADE always check to make sure that any paste, ink, or correction
fluid that is on the document is corrlpletely dry
• When cleaning the read area of the platen glass, take care not to damage the white roller located on the center of
the ADE
8-2
To Next Page
Loading...
