120 Maintenance Chapter 12
Setting The Power Save Timer
Power Save mode allows the scanning lamp is shut off, based on the length of time you specify
using the Power Save Timer setting. If you perform an operation immediately after recovering from
Power Save mode, the image may not be correctly read by the machine. If you use the machine
frequently, we recommend that you set the Power Save Timer to <4 HOURS> or <8 HOURS>.
IMPORTANT
• After recovering from Power Save mode, wait at least one minute before scanning, copying, or sending
faxes.
• The default setting is <1 HOUR>.
Follow this procedure:
1 Press [Additional Functions].
2 Use [W] or [X] to select <10.POWER SAVE TIMER>.
3 Press [Set].
4 Use [W] or [X] to select the time to switch the machine to Power Save
mode.
–<1 HOUR>: Switches the machine to Power Save mode if any key on the operation panel
is not pressed for one hour.
–<4 HOURS>: Switches the machine to Power Save mode if any key on the operation panel
is not pressed for four hours.
–<8 HOURS>: Switches the machine to Power Save mode if any key on the operation panel
is not pressed for eight hours.
5 Press [Set].
USER DATA
10.POWER SAVE TIMER
Ex:
POWER SAVE TIMER
1 HOUR
To Next Page
Loading...
