Setting Values Description
[RIP raster](default
[LINE_200LPI])
The default raster is [LINE_200LPI]. This is best
suited for over 95% of all prints. In special ca-
ses, for example moiré patterns from scanned
images, you can try to improve the print result
with the [DOT_200LPI] raster or even the
[DOT_125LPI] raster. However, then you may
loose some fine details.
The raster screen for PS/PDF jobs is
[LINE_200LPI]. All raster screens are compati-
ble with resolutions of 600x2400 dpi and
1200x1200 dpi.
Finishing settings
Finishing settings
Job setting What you can define
[Binding]
Binding method
Indicate how to bind your document.
[Folding]
[Creasing]
Folding or creasing method
Indicate how to fold or crease the printed documents.
[Trimming]
Trimming method
Indicate how to trim the printed documents.
[Punching]
[Perforating]
Punching or perforating method
Depending on the installed die set, select the method for punching
or perforating.
[Number of sets]
Setting Values Description
[Number of sets] [Check first set] When the [Check first set] setting is enabled,
the printer stops after the first set of a job has
been printed. You can check the quality of the
output.
NOTE
This setting is only available when in
the workflow profile [Check first set]
is set to [As in job].
[Number of sets] You can indicate how many copies of the job
you need. You can enter a value from 1 -
65,000. The default value is 1.
Overview of the available settings for DocBox jobs
Chapter 7 - Plan the jobs 175
Canon varioPRINT 140 series
To Next Page
Loading...
