Canon varioPRINT 140 Series - Shift the Image Roughly to Create Binding Space

Shift the image roughly to create binding space
Introduction
If you want to create space for staples or punch holes, for example, you can use the [Align]
function. The preview in the right-hand pane of the control panel displays the consequences of
your changes.
The [Align] function allows a rough image shift. You can select one of the following settings:
When you select: Then the image is moved to:
[Top left] The upper left corner of the sheet.
[Top center] The upper center of the sheet.
[Top right] The upper right corner of the sheet.
[Center left] The left-hand side of the sheet, over the center line.
[Center] The middle of the sheet.
[Center right] The right-hand side of the sheet, over the center line.
[Bottom left] The lower left corner of the sheet.
[Bottom center] The lower center of the sheet.
[Bottom right] The lower right corner of the sheet.
[Align] values
NOTE
You cannot change this setting for the active print job
.
Procedure
1.
On the control panel, touch [Jobs] -> [Queues] -> [Scheduled jobs] or [Waiting jobs], or select a
DocBox.
2.
Touch the job you want to change.
3.
Touch [Edit], or double-tap the job to open the [Edit] window.
4.
Touch the [Align] button.
5.
Make the required changes.
6.
Touch [OK].
Shift the image roughly to create binding space
216 Chapter 8 - Carry out print jobs
Canon varioPRINT 140 series