Canon varioPRINT 140 Series - Validate a Transaction Setup

Validate a transaction setup
What is transaction setup validation
When you use the [Validate] option, the printer checks for each tray if the media definition is
valid. It depends on the tray selection mode ([Tray to media] or [Tray to tray]) if the media in the
logical trays (tray to media table in setup) or the media in the physical tray (tray to tray) are
checked.
Validate the transaction setup to check the media definitions of the selectable trays
• when you have defined, changed, or imported a transaction setup
• when media or the media family was changed
• only for the tray selection mode [Tray to tray]: when you have loaded or will load the
transaction setup, or when the physical tray configuration changes.
Validation in [Tray to media] mode
The printer checks if the media set per logical tray in the tray to media table of the setup are
available in the media catalog.
Validation in [Tray to tray] mode
The printer checks if the media assigned to the physical trays in the tray view in the control panel
are available in the media catalog.
Validate a transaction setup
1. Open the Settings Editor and go to: [Transaction printing]→[Transaction setups].
[Transaction setups] menu
2. Click [Validate].
3. The report appears.
4. Evaluate the report and take action if required.
5. Click [OK] to close the report.
Validate a transaction setup
260 Chapter 8 - Carry out print jobs
Canon varioPRINT 140 series