Canon varioPRINT 140 Series - Staple, Punch, Fold, or Trim the Output

Staple, Punch, Fold, or Trim the Output
NOTE
When you make one copy of one original, stapling is not possible.
Procedure
1.
Place the originals face up into the automatic document feeder (ADF), or place one original face
down on the glass plate.
2.
On the control panel, touch [Jobs] -> [Copy/Scan] -> [Copy job].
3.
At the [Binding] setting, select the required number of staples and the location of the staples.
4.
At the [Punching] setting, select the punching or perforating method.
5.
At the [Folding] setting, select the folding or creasing method.
6.
At the [Trimming] setting, define the trim settings
7.
If required, define the other settings for the original document and the output.
8.
Enter the generic values in the [Job] section.
9.
Touch [Start]
.
Staple, Punch, Fold, or Trim the Output
Chapter 9 - Carry out copy jobs 295
Canon varioPRINT 140 series