Configure the Settings for Scan to SMB
Introduction
To use the scan-to-SMB function, the system administrator must enable this function in the
Settings Editor on the PRISMAsync controller ([Configuration] -> [Connectivity]). The system
administrator must add SMB shares ([Workflow] -> [SMB shares]). The maximum number of SMB
shares is 3. When required the system administrator can add SMB directories to a share. A scan
job will be sent to the selected SMB share or SMB directory.
How to Configure the Settings for Scan to SMB
The table below describes the settings that the system administrator must configure in the
Settings Editor.
Setting Description
Enable [Use of scan function] in [Configuration]→[Connectivity]→[Scan to file]
[Use of scan function] This setting must be set to [Enabled] to use the scan
function.
Add SMB shares in [Workflow] -> [SMB shares]
[Name] The name of the SMB share.
[Description] The description of the SMB share.
[Network destination] Select [Domain] or [Workgroup].
[Domain name] Name of the domain.
[Username] The user name that is used to access the SMB server
when sending scan jobs.
[Password] The password that corresponds with the user name.
[Path] The directory on the SMB server to which the scan jobs
will be sent.
Settings for scan to SMB in the Settings Editor
Configure the Settings for Scan to SMB
Chapter 10 - Carry out scan jobs 303
Canon varioPRINT 140 series
To Next Page
Loading...
