Canon varioPRINT 140 Series - Replace the Heat Exchanger Foils

Replace the Heat Exchanger Foils
Before you begin
NOTE
This POC action is available, depending on the type of the heat exchanger foils.
1. On the control panel, touch [System] -> [Maintenance] -> [Go to maintenance tasks] ->
[Replace the heat exchanger foils] -> [Start].
2. [Enter the maintenance PIN.]
3. [Touch Next to unlock the door.]
Required tools
Socket wrench
New heat exchanger foils
CAUTION
Only trained personnel is allowed to carry out POC actions.
Illustration
Required tools
Replace the Heat Exchanger Foils
462 Chapter 14 - Maintain the print system
Canon varioPRINT 140 series