Remove the punch waste in the stacker/stapler (Staple Finisher-AG
and Booklet Finisher-AG)
The dashboard of the control panel indicates if the punch waste tray is full.
You can check the current status of the punch waste tray at the control panel. Location: [System]
→[Printer]→[Finishers].
The print system cannot punch when the punch waste tray is full. This instruction only describes
the removal of punch waste of the stacker / stapler. Refer to the user manual of the professional
puncher how to remove punch waste from the professional puncher.
Location of the punch waste tray
IMPORTANT
Take care when you do maintenance tasks in optionals attached to the machine. When you do a
maintenance task, such as replace a staple cartridge, remove waste, or solve jams, other
machine parts can continue with job process activities.
Procedure
Action
1 Open the front cover of the stacker / stapler.
3 Pull out the punch waste tray.
NOTE
Check that the guide (F-A2) is closed.
When the guide is open, you cannot
pull out the punch waste tray. If ap-
plicable, close the guide.
4
Remove the punch waste in the stacker/stapler (Staple Finisher-AG and Booklet Finisher-AG)
Chapter 14 - Maintain the print system 521
Canon varioPRINT 140 series
To Next Page
Loading...
