Canon varioPRINT 140 Series - Manually Start a Drum Cleaning

Manually Start a Drum Cleaning
Introduction
The cleaning procedure consists of the following steps:
• The drum cools down. The control panel indicates the time required.
• The drum is cleaned automatically. You cannot interrupt this action.
When to do
When the prints contain dots.
Procedure
1.
On the control panel, touch [System] -> [Maintenance] -> [Go to maintenance tasks] -> [Clean the
drum] -> [Start].
2.
[Enter the maintenance PIN.]
3.
Follow the instructions on the control panel.
Manually Start a Drum Cleaning
Chapter 14 - Maintain the print system 529
Canon varioPRINT 140 series