[Finishing] settings Description
[Sheet order] Select the order of the prints in the output tray.
[Feed edge] Select the orientation of the prints in the output tray.
[Header orientation] Select the header orientation of the prints in the output tray.
[Print order] Indicate the delivery order of the sheets.
[Offset stacking] Indicate if the stacking occurs with or without an offset.
[Offset after N sets] Indicate if a group of sets is delivered with an offset. N means the
number of sets in a group.
[Punching] Select the number of punch holes and their location.
[Perforating] Select the perforation type and location.
[Folding] Select the folding method.
[Fold side] Indicate the fold side: [Inside] or [Outside].
[Creasing] Select the creasing method.
[Sheets] Indicate the pages you want to crease.
[Trimming] Select the trimming method.
[Print trim marks] Indicate if you want to print trim marks.
[Width ({0})] Enter the width of the trim marks.
[Height: ({0})] Enter the height of the trim marks.
[Horizontal trim shift: ({0})] Use this setting to shift the trim marks horizontally.
[Vertical trim shift: ({0})] Use this setting to shift the trim marks vertically.
[Horizontal alignment] Indicate if the trim marks need to be aligned horizontally.
[Vertical alignment] Indicate if the trim marks need to be aligned vertically.
[Print quality] settings
[Print quality] settings Description
[Contrast] You can indicate the contrast of the print.
[Brightness] You can indicate whether the print must be darker or lighter.
[Resolution] Use this setting to indicate the print resolution.
[Halftoning] You can indicate whether the job must be printed [Line 200 LPI],
[Dot 200 LPI] or [Dot 125 LPI].
4
Edit with automated workflow in job destination
Chapter 5 - Prepare the print system 91
Canon varioPRINT 140 series
To Next Page
Loading...
