Canon varioPRINT 140 Series - Activate the Hotfolder Function

Activate the hotfolder function
Introduction
The information in this section is intended for system administrators.
NOTE
By factory default, the hotfolder function is disabled. To use the hotfolder function, the system
administrator must activate this function once. After the system administrator activated the
hotfolder function, up to 10 hotfolders can be defined.
NOTE
For this procedure, the System administrator password is required.
Procedure
1.
Open the web browser and enter the host name or IP address of your PRISMAsync controller.
2.
Select [Workflow] -> [Hotfolders].
3.
Click [Configure].
4.
At [Enabled], select [Enabled] to activate the hotfolder function.
5.
Enter a unique user name and password.
Make sure that you filled in the user name and password before you continue with the next step.
6.
Click [OK] to confirm the activation of the hotfolder function.
A confirmation window opens.
7.
Click [OK] to restart the controller now.
Activate the hotfolder function
96 Chapter 5 - Prepare the print system
Canon varioPRINT 140 series