Canon VI T - Film Loading

IJfi up the Rewind Crank <I3),
Pul the film cartridge in the rcccjvs directly bcncaih the Rewind Crank*
t>epress the Kilm Rewind Crank (13) again to lock the film cartridge in place*
With your thumb on the knurled lower end of the Takc*up Spool (31K
turn the spool clockwise half a turn until the film is taut, (Re sure the index
line of the Film Rewind Ring (8) t'loints to the ‘*A" position*!
The camera back W'ilf lock shut automatically when you close it. Turn
the Magazine Otx:ning Key (27) clockwise to “close/’ Next, wind film one
turn and press the Shutter Release Hutton (9k By doing this you will have
cleared the two frames already exposed to light w'hilc you were loading.
The red dot on the Film Transport Indicator (19) makes one complete
turn each time you advance the film one frame. You will know- you have
loaded correctly if the indicator line on the Crank Shaft turns counter-clock¬
wise each time you cock the shutter mechanism.
17
FILM
LOADING