1. SAFETY INSTRUCTION 1-2
11. SECURE WORK.
Use clamps or a vice to hold work when practical. It is safer than using your hand and frees
both hands to operate the machine.
12. DO NOT OVERREACH.
Keep proper footing and balance at all times.
13. MAINTAIN MACHINE IN TOP CONDITION.
Keep machine clean for best and safest performance. Follow instructions for lubricating and
changing accessories.
14. DISCONNECT MACHINE FROM POWER SOURCE.
Before servicing and when changing accessories, or when mounting and remounting motor.
15. USE RECOMMENDED ACCESSORIES.
Consult the owner's manual for recommended accessories.
16. NEVER LEAVE MACHINE RUNNING UNATTENDED. TURN POWER OFF.
17.
Protective guards and shields must be in place at all times unless that specific part requires
servicing.
18.
Never clean or remove chips while the machine is running.
19.
Do not remove or alter warning labels and replace any that become obscured.
1. SAFETY INSTRUCTION 1-3
1.1.2. ADDITIONAL SAFETY RULES FOR AUTOMATIC MILLING MACHINE
1. Proper operation of this machine requires the specific knowledge of the following instructions
and of the risks consequent to improper utilization.
2. Therefore only qualified and authorized personnel must operate the machine. The operator will
be trained on the proper use of the equipment, its protection devices and accessory tools.
3. Safe operation of the machine is guaranteed only for the functions and materials indicated in
these user's instructions. We decline any responsibility if the machine is used for purposes
outside those indicated in the user's instructions or not complying with them.
4. We declines any responsibility related to equipment safety, reliability and performance if
warnings and instructions contained in this manual are not observed, with specific reference to:
Equipment utilization, routine and emergency maintenance, repair.
5. The manufacturer declines any responsibility if the machine is not properly connected to the
equipotent ground line or if the appropriate circuit breakers are not installed and coordinated
between electrical power lines and the machine, according to the above Regulations.
To Next Page