8. VOLTAGE
Before operating this unit, please refer to the data plate mounted at the back of the spotlight to insure
you are connected to the correct voltage.
9. FREQUENCY (Metal Halide units only)
Frequency on all units distributed in the U.S. by Strong Entertainment Lighting is factory-set to 60 Hz.
10. FUSE (Metal Halide units only)
Please refer to the data plate to check on the fuse required for the unit you have purchased.
11. INSTALLING or REPLACING THE BULB
Although this unit is supplied with a double-pole interlock microswitch, we strongly recommend you
disconnect the followspot from the power source before mounting the bulb.
a. Choose a suitable lamp type from the following list:
Metal Halide
OSRAM Philips
6000° K 7200° K 6000° K 7200° K
Canto 575 HSR 575/60 HSR 575/72 MSD 575 MSR 575
Canto 700 HSR 700/60 n/a MSD 700 MSR 700
Canto 1200 HSR 1200/60 n/a MSD 1200/2 MSR 1200/2
Tungsten-Halogen (ANSI)
Canto 1000 EGT (G22 Base)
Canto 2000 CP79 (GY16 Base)
b. Tilt the spotlight downward and locate the lampholder block in the bottom of the lamphouse. Open
the lampholder block by turning (counterclockwise) the two quarter-turn fasteners.
c. Pull the lampholder block down and insert the correct bulb in the lamp holder.
MAKE SURE THE LAMP IS CORRECTLY POSITIONED AND PERFECTLY VERTICAL
d. Carefully raise the lamp block and secure by turning (clockwise) the two quarter-turn fasteners.
Strong declines any responsibility for poor performance of the unit or
damages to the inner components if a non-compatible lamp is used.
5
To Next Page
Loading...