99
LOCATION
Your gas appliance must be installed on a flat, stable surface, away from any
combustible materials or construction.
Your gas appliance comes assembled, ready for a gas connection.
1. Remove the appliance from container box and place it on any level, outdoor,
non-combustible
surface.
NOTE: Do not place this appliance on grass or dirt area. This may prevent proper safety venting.
2. Open the gas door, put the cylinder inside.
3. Unscrew the battery box as shown in Fig. 3. Insert the negative electrode side of the
battery into the bottom of battery box as shown in Fig. 4. Then replace the battery
Fig. 3 Fig. 4 Fig. 5
Note: If the battery of the pulse electronic igniter runs out of power, please replace
with a new battery following the above instructions.
1. Open the door, put the chain and control valve outside (see Fig. 6).
2. Put the cylinder into the cylinder rack (see Fig. 7).
3. Connect the regulator and the cylinder as per Fig. 8. Make sure there is no leakage or
damage (please refer to Leak Test on page 10 and how to check for damage on page 5).
4. Secure the cylinder with the chain (see Fig. 9).
box as shown in Fig. 5.
SET-UP GAS CONNECTION
. 7 giF. 6 giF
To Next Page
Loading...
Need help?
General
