• Do not remove the rubber
or plastic liners inside the
motor base.
• Use a sponge or dish cloth
dampened with warm
soapy water to wipe down
the inside and outside of
the motor base until clean.
• Pay particular attention to
the actuator tabs on the
inside of the motor base to
loosen any stuck or sticky
debris from drips and
spills. If necessary you may
use a small brush to scrub
the area to ensure it is kept
clean.
CROSS BLADES:
Do not remove the
gasket as this may
permanently damage
the cross blade and
cause leakage.
• If after washing as
indicated additional
disinfecting is desired,
you may rinse with a 10%
vinegar/water solution.
If, over time, the gasket
becomes loose or
damaged, you may order
a new cross blade at
nutribullet.co.uk or contact
Customer Service for a
replacement cross blade.
• Dry the cross blades
completely. It is helpful to
turn the blade on its side
in your dish drainer to
ensure BOTH SIDES of the
cross blade are completely
dried.
• We recommend replacing
your Magic Bullet
®
cross
blade every 6 months or
as needed for optimal
performance. To order
replacement cross blades,
simply visit:
nutribullet.co.uk.
BLENDING CUPS
CUPS, LIDS AND LIP RINGS:
• These items are all TOP
RACK dishwasher safe. We
recommend rinsing them
and giving them a quick
brush with a dish brush to
remove any dried debris
before washing them in the
dishwasher. NEVER use the
sanitize cycle to wash the
blending cups as this may
warp the plastic.
• Regularly check the tabs
(3) on the sides of the cups
for damage (cracking,
crazing, breakage or
rounding). If the tabs are
damaged, discontinue use
and replace immediately to
prevent possible personal
injury.
Save These
Instructions!
7 8
To Next Page
Loading...