4
OPERATING YOUR WINE CABINET
AND SETTING THE TEMPERATURE CONTROL
Please use the cabinet within a ambient temperature of 5-32 °C, if the ambient temperature is
higher than or lower than this temperature, it will cause a temperature fluctuation in the
cabinet and may prevent is reaching 5-18 °C
¾ Controls
• “Run”
Indicator light illuminates to signify the cooling mode is currently in operation.
• “Light ”Button
To turn the inner light on/off.
• “Power” Button
To turn this appliance on/off
( press and hold this buttons for approximately
3 seconds).
• “Up” Button
Used to raise (warm) the temperature by 1°C .
• “Down” Button
Used to lower (cool) the temperature by 1°C.
Setting the temperature controls
• To set the temperature, connect the power cord to a properly grounded outlet In the event of a
power interruption, the previous temperature setting is automatically erased and it will default to a
preset temperature setting of 12°C
• Set the desired cooling temperature by pressing the buttons adjacent to the “UP/DOWN"
program. Each depression of the buttons will scroll through the available temperature setting in
increments of 1 degree. The temperature selected will flash in the LED display for approximately 5
seconds, then revert back to display the temperature of the internal cabinet.
• The temperature setting can be adjusted from 5°C ~18°C.
• To view the actual temperature, (anytime) press and hold the corresponding button for
approximately 5 seconds, the actual temperature will temporarily "flash" in the LED display for 5
seconds
• Flashing LED = Set Temperature
Steady LED = Cabinet Temperature
To Next Page
Loading...
