C 0609 / YC-CDA19Q
USB CHARGER EN
Warning: Please read this instruction manual carefully before using the instrument and keep it for future use.
Suitable for: tablets, smart phones, e-readers or any other device charged with a USB port.
INSTRUCTIONS:
• It is normal the devices are lightly warming when charging.
• Charge the devices in a room where the average temperature is between 32 ° and 80 ° F (0 ° and 27 ° C). A too cold room can harm
to the fine charge of the devices. A too high temperature can also harm the charge, even definitely damage the batteries or the
devices.
• Check the devices are correctly connected, respecting the power of each USB port.
• Quickly disconnect the devices when they are completely charged.
Warning charging light :
• When the devices are in charge, the LED display indicates the charging level of each device. The device corresponding number is
blinking.
• Once the batteries are completely charged, the device corresponding number switch off. The charge duration may vary depending
of each device. You can let the USB charger in use to ensure your devices are completely charged, but never exceed 4 hours once
charged, this could damage your devices or their batteries.
USB charger specifications:
Material : ABS
- output: 6 USB output 5V 8A max 40W. QC3.0 output 5V 3A- 9V 2A - 12V 1.5A Type C 5V 3A max
- input: secteur AC 220V 50Hz
SAFETY INSTRUCTIONS :
• Remove batteries promptly when fully charged. Overcharging may cause batteries to burst exposing surfaces to corrosives acids.
• Do not use an extension cord. It could cause a fire or electric shock.
• Do not charge damaged, rusted or leaking batteries.
• Do not use near water, flames or fire.
• Always unplug the Battery Charger and Tester after charging or testing is complete and before removing the batteries.
• The device is intended exclusively for private and not for commercial use. Only use this device as describe in this instruction
manual.
• Before to use, make sure that the supply voltage corresponds with the voltage marked on the rating label.
• Do not place any part of this appliance in water or any other liquid.
• Do not leave the device unattended when plugged in.
• Do not handle the unit or plug with wet hands.
• Unplug from the power outlet after use and allow the appliance to cool down completely before to clean it or to move it.
• When disconnecting the cable, always pull at the plug; do not pull on the cable itself.
• When using the device, always pull the power cord completely from its housing to prevent overheating.
• If the cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid
an electric shock.
80% more fast
To Next Page
Need help?
General