Need help?Do you have a question about the Car-O-Liner D16 and is the answer not in the manual?
General| Brand | Car-O-Liner |
|---|---|
| Model | D16 |
| Category | Industrial Equipment |
| Language | English |
Details the intended use of the draw aligner on specific alignment benches.
Identifies and describes the main parts of the draw aligner unit.
Explains the details and information found on the manufacturer's nameplate.
Emphasizes the importance of following manual instructions for safe operation and injury prevention.
Lists critical warnings, important notices, and information for user safety during operation.
Describes the meaning, colors, and purpose of various safety signs used on the equipment.
Illustrates the correct locations for affixing safety signs on the draw aligner D16.
Guides on adapting and fitting the draw aligner to Mark and BenchRack series bench frames.
Provides step-by-step instructions for correctly connecting and securing the draw aligner to the bench frame.
Explains the role of the safety plate and safety wire in preventing accidents and equipment damage.
Details how to position, link, and secure the draw aligner to the bench frame for safe operation.
Outlines essential checks and preparations, including hydraulic system bleeding, before alignment work.
Illustrates various pulling scenarios and setups, including recommended and not recommended configurations.
Describes using the EVO system for extra anchoring and holding of the vehicle to the bench.
Stresses the need for regular inspection and replacement of worn parts for the draw aligner.
Details checks for hydraulic components like piston rod, pins, washers, and couplings for leaks and damage.
Covers checks for bolts, screws, locking pegs, and the locking wedge for damage and proper function.
Instructions for draining oil and separating components for material recovery during dismantling or scrapping.
Lists the net weight and maximum cylinder pressure specifications for the draw aligner.
To Next Page