Need help?Do you have a question about the Cardi Coccodrillo 35 and is the answer not in the manual?
Ensures metallic parts are earthed for safety. Check socket, cords, and multiple sockets.
Ensures the PRCD works properly. Stop if it triggers.
Proper water flow is needed for cooling. Prevent water from entering electrical components.
Consult manager before cutting to avoid structural damage or building damage.
Secure the area for falling work pieces to prevent damage.
Fasten work pieces to prevent movement during cutting.
Use only CARDI-approved bars and chains for wet cutting.
Do not use chains for wood, tungsten carbide, or masonry due to kickback risk.
Always wear safety goggles, gloves, ear protection, and shoes.
Keep handles dry, grip firmly with both hands, use bar cover for storage.
Ensure power supply is properly earthed for safety. Ask electrician if unsure.
Select a suitable outdoor extension cord with ground conductor.
Check PRCD-GFI functionality by pressing Reset and Test buttons.
Connect chainsaw to water supply via quick connector. Max pressure 4 bar.
Periodically flip the bar for even wear. Replace bar after 2-3 chain replacements.
Check chain tension regularly. Proper tension increases productivity and safety.
Follow steps to safely mount and replace bar and chain. Ensure correct tension.
Check chain tension, plug in, check PRCD-GFI, connect water, grip saw firmly, and switch on.
Mark cuts straight. Plunge bar perpendicular. Rock saw for leverage. Avoid excessive force.
Perform horizontal or vertical cuts. Avoid handle downward position for horizontal cuts.
Rock saw when cutting reinforced concrete to prevent segment polishing.
Re-sharpen segments with water if cutting effectiveness reduces.
Clean chainsaw daily, remove slurry, oil chain tensioning system, clean bar and chain.
Service by qualified personnel only. Use original CARDI parts.
Provides a 24-month warranty in Europe under specific conditions.
To Next Page
General