Model 190 Installation, Technical and Operation
8400-M022-O1 Rev J
IMPORTANT! The following prompt, id= (ID Prompt) is
displayed after the touch= (Key Touch Sensitivity)
parameter ONLY in the Model 190A.
id= (ID Prompt)
The id= (ID=) parameter enables an ID prompt to be displayed
when the PRINT key is pressed and printed a ticket.
Press the TARE key to show the current setting. If the setting
displayed is acceptable, press the TARE key again to save it.
Otherwise, use the Fn/ key to toggle to a new setting and then
press the TARE key to save it. Allowable values are:
ID prompt will be displayed
when PRINT key is pressed
and printed on the ticket.
Normal print operation (no ID
prompt) will occur.
To Next Page
Loading...