Cardinal 190 Series - Page 161

Model 190 Installation, Technical and Operation
8400-M022-O1 Rev J
Page 151
Prty= (Optional Serial Interface Parity Setting)
Press the TARE  key to show the current setting. If the setting displayed
is acceptable, press the TARE  key again to save it. Otherwise, use the
Fn/ key to toggle to a new setting and then press the TARE  key to
save it. Allowable settings are:
0 = No Parity with 8 data bits
1 = Odd Parity with 7 data bits
2 = Even Parity with 7 data bits
Cont2= (Continuous Output on Optional Serial Interface)
Press the TARE  key to show the current setting. If the setting
displayed is acceptable, press the TARE  key again to save it.
Otherwise, use the Fn/ key to toggle to a new setting and then press
the TARE  key to save it.
YES = Continuous Output on Optional Serial Interface
no = No Continuous Output on Optional Serial Interface
IMPORTANT! The setting for the type= are only applied when
the opt= parameter is set to 1 and Cont2= parameter is set to
YES.
tyPE= (Continuous Output Format)
Press the TARE  key to show the current setting. If the setting
displayed is acceptable, press the TARE  key again to save it.
Otherwise, use the Fn/ key to toggle to a new setting and then press
the TARE  key to save it. Allowable settings are:
0 = Continuous Output uses SMA format
1 = Continuous Output uses Cardinal Scoreboard format
2 = Continuous Output uses Cardinal SB500 with traffic control format
NOTE: Refer to the CONT1= Continuous Output on Serial Interface,
tYPE= parameter section 4.8.1 and 4.8.2 for description of output
formats 0 and 1.