Cardinal 190 Series - Page 38

Model 190 Installation, Technical and Operation
8400-M022-O1 Rev J
Page 28
d oUt= X,Y (Digital Output)
Press the TARE  key to show the current setting. If the setting
displayed is acceptable, press the TARE  key again to save it.
Otherwise, use the Fn/ key to select the X, Y settings for the
Digital Output, and then press the TARE  key to save it.
where:
X = State below cutoff
(0=Output connected to common, 1=Output not connected to
common)
Y = Preset Number or Checkweigher Mode
0 =
Digital Output is disabled
1 =
Output connected to common before cutoff with 1
active Preset
2 =
Output connected to common before cutoff with 2
active Presets
3 =
Output connected to common before cutoff with 3
active Presets
4 =
Output connected to common before cutoff on
Checkweigher Mode
11 =
Output not connected to common before cutoff with 1
active Preset
12 =
Output not connected to common before cutoff with 2
active Presets
13 =
Output not connected to common before cutoff with 3
active Presets
14 =
Output not connected to common before cutoff on
Checkweigher Mode