Model 190 Installation, Technical and Operation
8400-M022-O1 Rev J
batt= (Battery Installed)
Press the TARE key to show the current setting. If the setting
displayed is acceptable, press the TARE key again to save it.
Otherwise, use the Fn/ key to toggle to a new setting and then
press the TARE key to save it. Allowable values are:
NOTE: If a battery is installed, select YES for the
batt= parameter. The battery charger will be turned
on automatically upon power up of the indicator.
toUCH= (Key Touch Sensitivity)
The Key Touch Sensitivity sets the minimum number of
milliseconds the key must be touched before the key press is
acted upon.
Press the TARE key to show the current status for this feature.
If the setting displayed is acceptable, press the TARE key
again to save it.
Otherwise, use the Fn/ and UNITS/ keys to enter a new
setting (0 to 255) and then press the TARE key to store the
new setting.
To Next Page
Loading...