Cardinal 190 Series - Page 64

Model 190 Installation, Technical and Operation
8400-M022-O1 Rev J
Page 54
Cont1= (Continuous Output on Serial Interface)
Press the TARE  key to show the current setting. If the setting
displayed is acceptable, press the TARE  key again to save it.
Otherwise, use the Fn/ key to toggle to a new setting and then
press the TARE  key to save it.
YES = Continuous Output on Serial Interface
no = No Continuous Output on Serial Interface
If Cont1= YES (Continuous Output) is selected, an
additional prompt, tYPE= will be displayed.
If Cont1= no (No Continuous Output) is selected, proceed
to the Weight On Demand section. (See Paragraph 4.8.3)
tyPE= (Continuous Output Format)
Press the TARE  key to show the current setting. If the setting
displayed is acceptable, press the TARE  key again to save it.
Otherwise, use the Fn/ key to toggle to a new setting and then
press the TARE  key to save it.
Allowable settings are:
0 = Continuous Output uses SMA format
1 = Continuous Output uses Cardinal Scoreboard format
4.8.1 SMA Continuous Output Format
If SMA is selected, data will be transmitted in the following format:
<lf><s><r><n><m><f><xxxxxx.xxx><uuu><cr>
Where:
lf =
Line Feed
s =
Flags
Z= center of Zero, O = Overcap, E = zero
Error, e = weight not currently being displayed
r =
Range
1
n =
Mode
G = Gross, T = Tare, N = Net
m =
Motion
M = Motion, " "(blank) = no motion
f =
Custom
Custom flag
xxxxxx.xxx =
Weight
Ten characters including decimal point (if any)
uuu =
Units
lb, oz, kg, g
cr =
Carriage
Return
(hex 0D)