Cardinal 190 Series - Page 69

Model 190 Installation, Technical and Operation
8400-M022-O1 Rev J
Page 59
g ACC= (Gross Weight Accumulator Print Location)
Press the TARE  key to show the current setting for the Gross Weight
Accumulator Print Location. If the setting displayed is acceptable, press
the TARE  key again to save it. Otherwise, use the Fn/ and UNITS/
keys to enter a new location and then press the TARE  key to save it.
n ACC= (Net Weight Accumulator Print Location)
Press the TARE  key to show the current setting for the Net Weight
Accumulator Print Location. If the setting displayed is acceptable, press
the TARE  key again to save it. Otherwise, use the Fn/ and UNITS/
keys to enter a new location and then press the TARE  key to save it.
CoUnt= (Count "number of pieces on the scale" Print Location)
Press the TARE  key to show the current setting for the Count Print
Location. If the setting displayed is acceptable, press the TARE  key
again to save it. Otherwise, use the Fn/ and UNITS/ keys to enter a
new location and then press the TARE  key to save it.
EACH= (Piece Weight Print Location)
Press the TARE  key to show the current setting for the Piece Weight
Print Location. If the setting displayed is acceptable, press the TARE 
key again to save it. Otherwise, use the Fn/ and UNITS/ keys to
enter a new location and then press the TARE  key to save it.
CRLF= (Carriage Return Line Feed) - Data Format Termination
Data transmitted from the serial I/O port can be terminated with a single
carriage return and either no line feed or a single line feed command.
Press the TARE  key to view the current setting. A YES on the display
means the data will be terminated with a carriage return AND a line feed
while a no on the display means the data will be terminated with a single
carriage return only.
If the setting displayed is acceptable, press the TARE  key again to save
it. Otherwise, use the Fn/ key to toggle to a new setting and then press
the TARE  key to save it.